All parts are delivered packaging ready

Windscreen, GFK or carbon become originally BMW the stops, at this with this one

 screws fastens enclosed.

K 1200 R.

The fastening is originally possible for hold circuit BMW sports windscreen only at this!

Please use the enclosed screws.

Sports windscreen unscrew new Schwabenmax part screw on.

R 1200 GS

Leadership nuts get original parts used to, on the left/on the right as well as this one

4 synthetic material washers.

The fastening is originally possible for hold circuit BMW GS windscreen only at this.

The inclination adjustment is absolutely possibly but not the BMW Fastening parts.

Please, you use the enclosed rubber distance plates on the left/on the right

Windscreen and hold circuit.

Asks the original BMW leadership nut on the left/on the right use you for the fastening

 as well as the enclosed Imbuß screws.

You you windscreen drive at construction plate, please put this together before if this.

The plate is fastened with 3 rubber nuts, rubber distances and Imbußbolts.

Plugging the rubber nuts of the outside by the existing drillings in.

The plate of the lower hold drilling screws on some turns

( Put Rubberdisc between this), then optional above on the left/on the right

Screwing on (putting Rubberdisc between this respectively).

Evenly puts on to screws to rubber nuts tightly all be on.

To the adjustment if the plate is equipped with oblong holes to the elevation adjustment, this one

Only on the whole the plate can then this undo screws tighten be moved again. 

Painting work:

You give this your varnisher to the knowledge!

Become a production since our models are designed very effortfully multisectional

Tools needed.

K 1200 R is a three-part R 1200 GS a five-part tool.

At every partition of the tool small seams are visible in the whitely shiny surface to the Entformen.

All our GFK parts are covered with a thick layer Gelcoat (white surface) in the outside area.

We recommend top paintwork around one the following working steps getting

1. You use a small flexible dragging block or e.g. styrofoam with abrasive paper

    180 grain the seams plan over-bows.

2. You use a styrofoam block a cigarette packet approx. 20 mm thickly, in the size,

 You sharpen the whole white layer water abrasive paper 400 until the gleam has disappeared therefore knows dully grain!

     Then not the edges if you wish beautiful edges, round over-bows!

A spray can paints 1 x, with mat black (contour colour) from the whole easy with pad

and 800 -1000 fogs, after drying with styrofoam block and water abrasive paper grain

even fine bows.

This must also sharpened and gefüllert will if the inside shall be painted.

The Carboninside shall sufficed if it, this whole before be painted with e.g. Clearpaint

 sharpening with a dragging pad.

 The Carbonside shall not cleanly be painted, please, if abkleben!

Leave the lacquered part at least 3 days in a warm room before the packaging!

Caution:

By the extension of our windscreen the aerodynamics partly changes considerably compared with the series, the wind pressure especially is substantially lower at high speeds up as of 180 km/h and other Luftverwirbelungen appear.

In the interest of your own drive initially more carefully and get used to the new conditions.

We always wish you a lot of fun and rope journey BMW with yours, you always come home healthily.