|
| ||
|
|
| |
|
| ||
|
Cultivation instructions Tail Increase BMW, K 1200 S -R /sports GT
Please, follow these instructions around everybody to avoid errors! We recommend to have anybody carry out the installation in a special workshop! One construction time 15 -20 minutes.
1: Guaranteing a motorcycle on the main column. Putting a motorcycle on a sure holding appliance, if no main column is available. Caution: Raise not at the Rear wheel (Axis) by means of an on-buck device!
2:This one removes hold plates the nuts originally with suitable tool (on the right) Take a right plate the this one, with a small rubber or synthetic material hammer screws from the right coming through by knock and pull out on the left. Caution! Pull not the store hulls out!
3: use and you the opportunity how they grease the 3 needle bearings with suitable bearing grease follow: You shove the store hulls approx. 2/3 out from an arbitrary side and lubricate You store grease to the exposed store. You then repeat the process of it other side. Caution! The danger passes this this one if you completely pull the store hulls out Fall needles of the store out!
4. mount you con side the BRM Plate as follows, on of this one now the rope raise the rear wheel for a help person to this.
4/1. The 3 originally grease screws before the packaging, not the nuts! 4/2. plate on it hold the front screw complete by stick.
Photo 1
4/3, on the this suitably brings hold drilling to the Umlenkhebel (bone), to this Raise rear wheel the screw by stick, this her on the back not juts out.
Photo 2
4/4. Putting the right plate on and the nuts attracting some turns by hand. 4/5. The hold drillings are drilled 4/5th respect (series 10th 2 -10,3 exactly on 10 mm) Through this screw must at the packaging of 3 the drilling be fixed exactly. The screw can sucking by hand be mounted!
Please, do not use force, please work with sensitivity, a hammer or different one Blow tool is not necessarily !!
4/6. Correctly all 3 hold bolts mount if the original nuts is you relieve off, you degrease the thread coming through you take a little engine tide screw protector you screw in tight the nuts one evenly into the nuts, Anzugsdrehmoment according to the BMW -- workshop manual 38 Nm. Photo4
Bild 3 Bild 4
Caution: The seat position/ground clearance change this one by our Heckhöherlegung in the area
Driver notch by approx. 17.5 mm to 26.5 mm depending on variant give way considerably more handily more willingly and react to steering impulses more spontaneously. You approach the thing in the interest of your own with the advisable caution to you himself have stand and road performance accustomed the new!
|
