Cultivation: Spoiler plate BMW K1200 R

1. lower drilling in original plate, 9.5 mm

2. Fixing the thickness rubber plate at the MRA plate of two upper drillings on the drilling with e.g. scotch tape suitably

3. plates below with rubber nut and small rubber plate between this mount, tighten

4. plates fixing small brackets or adhesive tape suitably and marking both upper drillings or slitting slightly with small Kerner above.  

5. Above at least 1 get a little steeper thicknesses rubber between put or 1 thick one and 1 thin one

Caution! The drillings with a small drill vorbohren e.g. 3 mm and with small mills (conical grinding stone) on 9.5 mm enlarge 

See pictures