Alu-Schwinge K & J

 

Please proceed exactly after these installation instructions.

You use components, gas handle bracket, clutch head screw, handle bowl, only delivered by us
Packaging time approx. 10 minutes!
Please, you test the Freerunning of the gas train after/handle, . ended Mounting this must reverse by oneself into the starting point.

Danger note:
Please, you take this into account the vehicle more spontaneously reacts to gas handle movements by the packaging of our gas path shortening. Drive have you got used to the new circumstances with an advisable caution to you!

We always wish a rope journey
Team Schwabenmax

 

 

 

  Gashandle Case unscrewing
     
accelerator clearance maximum

shift on
     
  accelerator down on the gashandle case complited screw on
     
Unhooking accelerator, raising with a small flat screwdriver.
     
  Get out the accelerator
     
  Gashandle of fullspeed
     
  Gashandle case
     
  Import bracket and into the groove a clipsen
     
  Reversing gas handle on zero
     
  Importing and screwing in tight

the accelerator
     
  get ou the Accelerator with your hand
     
  Holding  tight and inserting in leadership
     
  Start the motorcycle

A max. bias voltage increases Accelator below ready leaders to the open-circuit operation speed!
 Slowly reverses to open-circuit operation speed constantly is
     
Approx. 2-4 mm adjust gas handle empty game with the digital measuring Tool

or

3 to 4 turns then fasten an adhesive tape to the marking reverse

 
     
 
This only applies respect to the models listed here followingly
 
R1200S /R  
R1200GS /ADV (Bj. 01/2004 - 08/2005)
R1200GS /ADV (Bj. 09/2005 - 12/2007)
R1200GS /ADV (Bj. > 2008)
HP2 Sport (Bj. > 2008)
HP2 Mega Moto (Bj. > 2008)     
     
A right gas handle must be cut off by the customer the blue nipple indicated here with a knife. This nipple has no functional disadvantage this be missing. The handle does not have to be removed to this.